Equinox Systems Fusion 140 - Master;Slave Mode

www.prolight.co.uk Fusion 140 User Manual
9
Show mode:
To access the show modes, press the “MENU” button to show “Show Mode” on the LCD display. Now
press the “ENTER” button and use the “UP” and “DOWN” buttons to choose between
“Show 0” ~ “Show 7” (Show 7 – forward facing show). Press the “ENTER” button to conrm the setting.
To exit out of any of the above options, press the “MENU” button.
Master/slave mode:
To set the master unit, press the “MENU” button to show “Slave Mode” on the LCD display. Now press
the “ENTER” button and use the “UP” and “DOWN” buttons to choose “Master”. Press the “ENTER” but-
ton to conrm the setting. Then select your desired program.
To set the other units in slave mode, press the “MENU” button to show “Slave Mode” on the LCD dis-
play. Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose either “Slave1” or
“Slave2”. Press the “ENTER” button to conrm the setting.
The unit will now run in sequence with the master unit.
To exit out of any of the above options, press the “MENU” button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Blackout setting:
To access the blackout setting, press the “MENU” button to show “Black Out” on the LCD display.
Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose between “No” or “Yes”.
Press the “ENTER” button to conrm the setting.
To exit out of any of the above options, press the “MENU” button.
PLEASE NOTE:The xture must be set to “NO” for Show modes to run.
Sound/sound sensitivity:
To turn the sound mode on or off, press the “MENU” button to show “Sound State” on the LCD display.
Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose between “On” or “Off”.
Press the “ENTER” button to conrm the setting.
To adjust the sound sensitivity, press the “MENU” button to show “Sound Sense” on the LCD display.
Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose between 0 ~ 100.
Value: 0 - 100 (0 = low, 100 = high)
To exit out of any of the above options, press the “MENU” button.
White balance setting:
To access the white balance setting, press the “MENU” button to show “White Balance” on the LCD
display. Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose between
“Red”, “Green” or “Blue”. Press the “ENTER” button and use the “UP” and “DOWN” buttons to adjust the
white balance between 50 ~ 255. Press the “ENTER” button to conrm the setting.
To exit out of any of the above options, press the “MENU” button.
Operating instructions