EasyManua.ls Logo

Equipter RB4000 - Before You Start Procedures; Operating and Load Handling Precautions

Equipter RB4000
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Always use the bubble level to help confirm that the Equipter is completely level any time the dump box is
not in the transport position.
The dump box must be in the transport position (fully forward and down on the frame) before driving or
towing the Equipter.
Always wear a hard hat when operating machine.
Know your equipment. Know how to operate all controls and know emergency shut down procedures.
Make sure all safety devices are in place.
Do not wear loose clothing or items such as rings and watches around the equipment. They could get
caught in moving parts and lead to serious injury or death.
Inspect the equipment. Check for missing shields, loose bolts, twisted or damaged hydraulic hoses. Be
sure all operational decals are in place and legible. Never operate a damaged or unsafe machine.
Keep all step plates, grab bars, pedals and controls free of dirt, grease, oil, and water. Keep area clear of
tools, rags, and extra parts. Keep equipment clean to help avoid injury from a fall when getting on or off
equipment.
Ensure machine is level and stabilized and that the brakes are properly set prior to operating the dump
box.
Check clearance on both sides before outriggers are lowered. Make sure personnel are clear of
outriggers.
BEFORE YOU START
LOAD HANDLING PRECAUTIONS
Know the work area before you begin. Observe any potential hazard areas such as soft ground, drop-offs,
rocks, and other obstacles.
Do not drive on hills above a 5% grade. Be aware of wet conditions which may allow the machine to lose
traction and slide on a hill.
Always lower outriggers before raising or extending the dump box.
Observe overhead electrical and phone lines. Be sure equipment will safely clear them.
Be aware of others in the work area. Be sure others know when and where you will be working. Make sure
no one is underneath or behind equipment.
Never try to board equipment while its moving.
Never allow riders or passengers while driving machine or operating the outrigger controls or dump box.
This machine is NOT to be used for personnel lift.
Be aware of what is going on around you. Watch for others who may not be watching out for themselves.
OPERATING PRECAUTIONS
6

Table of Contents

Other manuals for Equipter RB4000