The Operator’s Manual must be read and understood by the operator
The Equipter must be licensed and registered according to all local, state and federal laws
and regulations.
Some states require annual trailer inspections
Tow Vehicle Requirements
Tow capacity of at least 7500 lbs.
2-5/16 inch ball
Electric brake controller
Connect and Disconnect
Safety chains should be attached to tow vehicle before front wheels are raised or lowered.
Always disconnect and connect Equipter on level ground. If disconnecting or connecting on
level ground is not possible, use blocking in front of and behind rear wheels to prevent the
machine from rolling.
Trailer Connect
Position trailer hitch over tow vehicle ball
Fasten safety chains
Engage parking brake
Raise front wheels to lower hitch onto ball
Confirm front wheels are in locked position
Slightly engage the reverse drive lever to ensure the hydraulic motor has disengaged from
the rear axle
Stop engine and turn off fuel
Lock coupler and insert pin
Connect light plug
Fasten break-away switch (not to chains or removable hitch)
Raise and latch step
Disengage parking brake
Check hitch and safety chain connections
Confirm all lights and brakes work
OPERATIONS CHECKLIST
37
To Next Page
Loading...