EasyManua.ls Logo

Equipter RB4000 - Optional Mats; Figure 26. Preparing to Store the Mats; Chutes; Figure 27. Mat Storage

Equipter RB4000
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
Figure 30. Chutes in Use.
Mats allow the Equipter to traverse areas that would normally be damaged by a vehicle driving across. The
mats distribute the load across a wider foot print, provide improved traction on slippery surfaces, and are
lightweight and portable.
The mats store under the dump bed, sliding in from the rear. To store or remove the mats the dump bed
must be dumped slightly to allow sufficient clearance. After sliding them into the storage position, the
dump bed must be lowered back to the transport position.
Figure 26. Prepairing to Store the Mats. Figure 27. Mat Storage.
OPTIONAL MATS
The optional Chute kit “funnels” debris into the Equipter, reducing the need for repositioning. The Chutes
can be stored on the side of the dump box when not in use.
These chutes can be screwed or nailed onto the roof to “funnel” debris into the dump box. For most
efficient results angle the chutes towards the dump box using them as slide chutes.
CHUTES
Never step or walk on chutes. Chutes are not
designed as a support for personnel.

Table of Contents

Other manuals for Equipter RB4000