WARNING! When using mineral spirits, ground gun by holding it against
an earthed metal container while ushing. Failure to do so can result in
static electrical discharge, which can cause a re.
1. Separate the prime tube (6) from the pipe clips (9) (Step 1).
2. Place the prime tube (6) in waste bucket (Step 2).
3. Submerge the suction tube (7) in water or ushing solvent (step 3).
4. Turn the Prime/Spray lever (3) downward to the prime mode (Step 4).
5. Adjust the pressure control knob (22) at higher pressure setting (Step 5).
6. Connect to power supply and switch the product on (Step 6).
7. Paint sprayer will start pumping and water or ushing solvent as well as air bubbles
will be purged from system. Let uids discharge from the prime tube (6) into waste
bucket for 30 to 60 seconds.
8. Return the Prime/Spray lever (3) to spray mode for 30 seconds (Step 7).
9. Wait for the motor to automatically cut out.
WARNING! High-pressure uid from spray gun, hose leaks, or ruptured
components will pierce skin. This may look like just a cut, but it is a serious
injury that can result in amputation. Get immediate medical treatment.
– Do not point gun at anyone or at any part of the body.
– Do not put your hand over the spray tip (14d).
– Do not stop or deect leaks with your hand, body, glove, or rag.
– Always lock the trigger (15) when not spraying.
– Follow pressure release procedure in this manual, when you stop
spraying and before cleaning, checking, or servicing equipment.
10. Remove the prime tube (6) from the waste bucket and clip it back to the suction
tube (7) with the pipe clips (9) and submerge in paint pail (Step 8).
11. The product is ready for spraying paint.
NOTE: If the Sprayer constantly starts and shuts down, repeat steps
4 - 9. When enough pressure has accumulated in the hose, the motor
switches off automatically. The motor will automatically turn on and off
when it needs pressure.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 34 10/29/20 3:31 PM
35
To Next Page
Loading...
