Erbauer EAPS600 - Page 45

Problem Possible cause Solution
1. Product does
not start
1.1 Not connected to power
supply
1.1 Connect to power supply
1.2 Power cord or plug is
defective
1.2 Check by a specialist
electrician
1.3 Switch is not turned on 1.3 Turn on the switch
1.4 Pressure control setting is
too low
1.4 Turn the pressure control to
Max setting
1.5 Other electrical defect to
the product
1.5 Check by a specialist
electrician
2. Product does
not reach full
power
2.1 Extension cord not suitable
for operation with this
product
2.1 Use a proper extension
cord
2.2 Power source (e. g.
generator) has too low
voltage
2.2 Connect to another power
source
2.3 Air vents are blocked 2.3 Clean the air vents
3. Little or no
material ow
3.1 Suction tube (7) loose 3.1 Insert the suction tube (7)
3.2 Suction tube (7) clogged 3.2 Clean the suction tube (7)
3.3 Inlet valve (5) clogged 3.3 Press the valve clearance
button (5a) to release the
steel ball and clean the inlet
valve (5)
3.4 Paint outlet (4) clogged 3.4 Clean the paint outlet (4)
3.5 Spray nozzle (14f) clogged 3.5 Clean the spray nozzle
(14f)
3.6 Spray gun trigger (15)
blocked
3.6 Remove the paint near
spray gun trigger (15) and
clean the spray gun
3.7 Pressure control dial set too
low
3.7 Increase pressure control
setting
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 44 10/29/20 3:31 PM
45