19
The following function check should be carried out before each use and at regular
Intervals:
1. Switch the product on.
2. While the motor is running, engage the kickback brake to position
by rolling your
left hand forward against the front hand guard (6). Saw chain (3) and motor should
stop immediately.
3. Release the switch trigger and try to switch the product on.
4. The saw chain and motor shall not start.
5. Release the switch trigger and pull front hand guard backwards to position after
function check.
Operation
WARNING!
day and on what special days products are allowed to be used and
what restrictions apply! Ask your community for detailed information and
observe the regulations in order to preserve a peaceful neighbourhood
and avoid committing administrative offences.
01
The chain oil level and lubrication should be checked after everything else is ready
before cutting.
1.
2.
in Fig. I.
02
1.
operate chain saws safely and effectively. Familiarise yourself with all the controls
and switches. Practise all movements with the product switched off.
2.
and rear handle with the right hand. Fully grip both handles at all times during
operation. Never operate the product using only one hand.
3. Only use the product with a secure stance. Hold the product at the right-hand side
of your body.
4. Ensure that cutting object does not exceed the usable cutting length of the chain
saw. The tip of guide bar shall always be kept at least 5 cm outside the outline of
the wood log.
5. Ensure the saw chain is running at full speed before it makes contact with the
wood. Use the ridged bumper (5) to secure the product onto the wood before
starting to cut and use it as a leverage point while cutting.
To Next Page
Loading...
