700W HVLP SPRAY GUN ERBAUER
1. General operation
> Check the product, the power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
> Double check that the accessories are properly fixed.
> Always hold the product by its handle. Keep the handle and surfaces clean and dry
to ensure safe support.
> Release the trigger immediately if you are disturbed while working with it and when
other people enter the working area.
> Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete stop
before putting it down.
> Do not overwork yourself. Take regular breaks to ensure concentrated work and full
control over the product.
OPERATION
WARNING! In some countries regulations define at what time of the
day and on what special days products are allowed to be used and
what restrictions apply! Ask your community for detailed information
and observe the regulations in order to preserve a peaceful
neighbourhood and avoid committing administrative offences! (not
applicable for UK)
2. Spraying
NOTE: Perform several spray tests to select the correct paint/air ratio
with regulating the pattern adjustment knob and the fluid adjustment
knob. Start painting on the work surface after the tests show a
satisfied result.
> Set up a piece of cardboard or other scrap material to use as a target and adjust for
best spray pattern.
WARNING! Never aim or spray at yourself or anybody else which
would cause serious injury.
> Test the consistency of the material by making a few strokes on a cardboard
target. If material still appears too thick, add a small amount of thinner. Do not
exceed paint manufacturer’s thinning recommendations.
> Keep the spray nozzle (22) about 15 to 30 cm from the work surface. Move the
spray gun keeping perpendicular with spraying area.
> Completely pull the trigger (15) and
then move it parallel for several times.
Stopping gun movement in mid-stroke
will cause a build-up of paint and result
in runs. Do not fan the gun from side to
side while painting.
This will cause a build-up of paint in the
centre of the stroke and an insufficient
coating at each end (Fig. 11).
WRONG RIGHT
Fig. 11
To Next Page
Loading...
