700W HVLP SPRAY GUN ERBAUER
13. Trouble shooting
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!
Possible cause Solution
1. Product does not start
1.1 Not connected to
power supply
1.2 Power cord or plug is
defect
1.3 Other electrical defect
to the product
1.1 Connect to power
supply
1.2 Check by a specialist
electrician
1.3 Check by a specialist
electrician
2.
Product does not reach
full power
2.1 Use a suitable
extension cord
2.2 Connect to another
power source
3. Excessive
vibration/noise
3.1 Screw and nuts
loosened
3.1 Check screws and
nuts for tightness and
re-tighten as necessary
Problem
2.1 Extension cord not
suitable for operation
with this product
2.2 Power source
(e.g. generator) has
too low a voltage
12. Selecting the spray material
Measure the viscosity of the paint.
> To determine this first thoroughly
stir the paint. Dip the viscosity cup
into the paint and fill just below the
cups rim. Raise the cup and
measure the time taken for the
paint to run out .This will give a
D.I.N. The maximum viscosity for
this product is max D.I.N.50
(for 2.5 mm nozzle) 50 seconds.
To Next Page
Loading...
