700W HVLP SPRAY GUN ERBAUER
> Loosen the screw (7a) anticlockwise
and remove the cover (7b) (Fig. 16).
> Remove the filter (7c) and tap it on a
solid surface to remove dust. Use
compressed air (max. 3 bar) to
remove stubborn dust.
> Replace the cover (7b) and tighten
the screw clockwise.
!
1.000
7
7b
7a
7c
Fig. 16
7. Maintenance
B efore and after each use, check the
product and accessories (such as
application tools) for wear and damage.
If required, exchange them for new ones
as described in this instruction manual.
Observe the technical requirements.
8. Power cord
If the power cord is damaged, it must be
replaced by a special cord or assembly
available from the manufacturer or its
service agent.
9. Repair
Check for any damage and wear. Repair
damages in accordance with this
instruction manual or take it to an
authorised service centre before using
the product again.
This product does not contain any parts
that can be repaired by the consumer.
Contact an authorised service centre or
a qualified person to have it checked and
repaired.
10. Storage
> Clean the product as described above.
> Store the product and its accessories
in a dry, frost-free place.
> Always store the product in a place that
is inaccessible to children. The ideal
storage temperature is between 10 and
30°C.
> We recommend using the original
package for storage or covering the
product with a suitable cloth or enclosure
to protect it against dust.
To Next Page
Loading...
