> Trigger the spray gun properly. Start the gun moving at the beginning of the stroke
before squeezing the trigger (15) and release the trigger (15) before stopping the
gun movement at the end of the stroke. This procedure will blend each stroke with
the next without showing overlap or unevenness.
> The amount of paint being applied can be varied by the speed of the stroke, the
distance from the surface and the adjustment of the fluid adjustment knob (16).
> Overlap strokes just enough to obtain an even coat.
> Do not disrupt the paint flow by letting go of the trigger.
NOTE: Two thin coats of paint will yield better results and have less
chance of runs than one heavy layer.
3. After use
> Switch the product off, disconnect the product from the power supply and let it cool
down.
> Check, clean and store the product as described below.
4.The golden rules for care
WARNING! Always switch the product off, disconnect the product
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning work!
> Keep the product clean. Remove debris from it after each use and before storage.
> Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
> Inspect the product before each use for worn and damaged parts. Do not operate
it if you find broken and worn parts.
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
5. General cleaning
WARNING! Never use metal or other objects that could damage the
holes in the nozzle and cap. Never immerse the product completely
in solvent or other liquids.
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
> Clean the product immediately after each use. If the product clogs up, take steps
as described below.
> Release the trigger (15) and switch off the product.
> Clean all the paint passages and the nozzle after each use with a slightly damp
cloth and a little soap. Use the brush (not supplied) for hard to reach places.
To Next Page
Loading...
