14
CML International S.p.A.
• at this point with the use of the
and
buttons you may add or subtract
degrees to your original stored angle;
• Once the bend angle has been changed you will need to store it by pressing the
button.
CHANGING THE LANGUAGE
In order to change the machine language on the display please act as follows:
• Place the machine in the off position and then press the
,
,
simultaneously while turning on the machine;
• On the display the following message should be shown:
Language selection
By pressing the
button you may scroll through all the available languages;
• Make your selection then store with the use of the
button.
PRACTICAL USE OF THE MACHINE
Main points to keep in mind for bending correctly with the Ercolina® system:
♦ Before bending make sure that the outside diameter of the tube is of the same
size as the one printed on the former and the counterbending die.
!!Note: if you measure the former groove with a calibre, do not be surprised
to find it a few mm smaller ( if the wall thickness of the tube is smaller than
2,5mm ) or a decimal part of a mm smaller ( if the wall thickness of the tube
is greater than 2,5mm ) than the actual marked diameter size. It is perfectly
normal and it is part of the Ercolina® bending technology.
To Next Page
