8
CML International S.p.A.
Check that the line voltage is always compatible with the power supply for
which the machine has been manufactured for;
Make sure that only trained personnel operates the machine;
Keep the machine in a dry and safe place;
Delimit the machine’s working area with barriers and / or chains in order to
avoid non authorised persons entering the working area of the machine when
both in motion and switched off ;
Mark the working area with appropriate signals ;
Go to a safe place when the machine is in use;
Never stand next the machine on the opposite side of the controls;
Disconnect main power cable prior to transporting the machine;
Verify on a regular basis if formers and counterbending dies are worn out;
Wear protective gloves when handling the material;
Wear a protective helmet for upward moving or suspended tubes;
! Train adequately the operator in
charge of the machine.
MANDATORY
To Next Page
Loading...
