ErgoAV ERTSL2-01B - User Manual

Need help?

Do you have a question about the ErgoAV ERTSL2-01B and is the answer not in the manual?

Summary

Important Safety and Compatibility

TV Compatibility and Wall Preparation

Verify TV VESA pattern, weight, and wall construction for safe and secure installation.

Tools and Parts Overview

Required Tools and Supplied Parts

List of necessary tools and components provided for the initial steps of assembly.

Step 1: Attaching TV Brackets to TV

Selecting Correct Bolts and Thread Engagement

Choose appropriate bolts and verify thread engagement for secure bracket attachment.

Step 1: Attaching TV Brackets to TV (Variations)

Using Spacers for TV Attachment

Guidance on using spacers for various TV back types like curved, bumped, or recessed.

Step 1: Attaching TV Brackets to TV (Variations)

Attachment Options for Flat, Curved, Bumped TVs

Specific instructions for flat, curved, or bumped TV backs using different bolt/spacer combinations.

Step 1: Attaching TV Brackets to TV (Variations)

Cable Interference and Recessed Hole Solutions

How to use spacers for cable interference and to fill recessed holes on TV backs.

Step 2: Assembling the Base

Connecting Support Pillar to Glass Base

Assemble the base by connecting the support pillar to the tempered glass base using bolts.

Attaching Foot Pads to Glass Base

Place foot pads on the corners of the painted side of the tempered glass base.

Step 3: Connecting TV Plate to Support Pillar

Selecting TV Plate Mounting Location

Measure TV to bracket distance and use chart to select the recommended mounting location on the pillar.

Step 3: Connecting TV Plate to Support Pillar (Execution)

Attaching Swivel Component and TV Plate

Connect swivel component to pillar and TV plate to swivel component using specified bolts.

Step 4: Securing Wire Clips

Attaching Wire Clips to Support Pillar

Secure the provided wire clips to the support pillar for cable management.

Step 5: Attaching TV and Managing Wires

Hanging and Securing the TV

Hang the TV onto the TV plate and secure the bottom, following placement guidelines.

Step 5: Attaching TV and Managing Wires (Continued)

Inserting and Tightening Safety Locks

Insert safety locks into TV bracket hooks and tighten bolts to secure the TV plate.

Supplied Hardware for Step 6 A

Hardware for Wooden Table Furniture Installation

List of screws and washers required for Step 6A: Wooden Table Furniture Installation.

Safety Straps: Wall Mounting

Overview of Safety Strap Installation Steps

Guidance on using safety straps for wall mounting, referencing steps 6A, 6B, and 6C.

Step 6 A: Wooden Table Furniture Installation

Predrilling Pilot Holes for Wood

Instructions for predrilling pilot holes in wood furniture to prevent splitting and ensure secure mounting.

Step 6 B: Wooden Stud Installation

Verifying Stud Placement and Mounting

Instructions for mounting safety straps to wooden studs, including stud verification and strap placement.

Supplied Hardware for Step 6 C

Hardware for Concrete Installation

List of screws, washers, and wall anchors for Step 6C: Solid Concrete or Concrete Block Installation.

Step 6 C: Concrete Installation

Mounting to Concrete or Block Walls

Instructions for installing safety straps into concrete or concrete blocks, avoiding mortar joints.

Step 7: Swivel Adjustment

Manual Swivel Adjustment

Instructions on how to manually swivel the TV plate or the TV if needed.

ErgoAV ERTSL2-01B Specifications

General

Model	ERTSL2-01B
Category	Racks & Stands
Product Type	TV Stand
Placement	Tabletop
Load Capacity	100 lbs
Material	Steel
Color	Black
Tilt Range	±15 degrees
Mounting Pattern	VESA 200x200
Weight	2.6 lbs