Cleaning and maintenance
02/2021 1026110-00 Operating instructions – 43/58
4.8.1 Low pressure lamps
Replace faulty UV low pressure lamps immediately.
Always replace the entire set of lamps after the specified operating time.
– Turn 90° and carefully remove from the socket.
– Low pressure lamps possess a reflector which directs the light outwards.
The lamps must be mounted in such a way that the rear side of the re-
flector is located on the device side.
– Push the pins vertically into the socket from above.
– Turn the lamp 90°.
The lettering must be oriented towards the outside (i.e. towards the user).
To Next Page
Loading...
Need help?
General
