12
Adjust the rail to the proper
length and secure the rail
You will need the frame (composed of the lifting columns, the side
brackets, and the rail) and the M5 Allen key.
1. Set frame on the underside of the worksurface (table top),
loosen the screws that are in the rails (the screws are already in
the proper holes in the frame), and then align the frame holes
with the pre-drilled holes in the worksurface.
2. Secure the rails by rotating the screws mentioned above
clockwise using the M5 Allen key until they’re tight.
Step 3
Note: If no holes are pre-drilled, adjust the frame to the proper
length and center it on the underside of the worksurface. Follow
step 2 listed above (step 2 of step 3) and drill the holes in the
worksurface.
To Next Page
Loading...