ergonofis Shift - Initializing and First Use; Saving a Position

To Next Page

To Previous Page

Initializing

First Use

Plug the power cable into an electrical outlet and you may start

using your desk.

Saving a position

You can use this function to program your preferred heights for

standing and sitting.

1. Adjust the desk to the height you wish to save by

using the up/down arrows.

2. Hold one of the four memory buttons (shown as “1”, “2”, “3”

and “4”) for 5 seconds or until you hear a “beep”.

Note: You may constantly save new heights on top of existing

saved heights by following steps 1 and 2 above.