27
Recalling a saved position*
You can use this function to adjust the desk to your saved heights.
1. Press the desired position (shown as “1”, “2”, “3” and “4”).
2. The desk will automatically adjust and stop at the pre-set
position. You may hit the up or down arrow if you’d like to stop
your desk before it has reached its saved position.
*Use this function with caution. Make sure that nothing prevents your desk from raising or lowering
and that no one, including animals, goes under the desk while it’s moving. ergonos will not be held
responsible for any injuries caused by the mishandling of this function or any other incidents.
Setting height limits
You can program height limits directly with the handset. For
instance, if you have a ling cabinet of 27” high under your desk,
we highly suggest that you program a height limit directly above the
cabinet. This will ensure that the desk never goes lower and bumps
into the top of the cabinet.
1. Adjust the desk to the desired height limit by using the
up/down arrows.
2. Press and hold both “1” and “2” at the same time for 5 seconds
or until you hear a “beep” to set the height limit when lowering
the desk or press and hold both “3” and “4” at the same time for
5 seconds or until you hear a “beep” to set the height limit
when raising the desk.
To Next Page
Loading...