3. Safety regulations
- 12 -
Inform yourself!
Before usage, the manual has to be read and understood.
Service and maintenance has to be done by trained staff only.
Protect yourself!
Wear eye and hand protection (cut proof
gloves) and also safety shoes.
Attention: Laser beam!
Direct eye contact with the laser beam or reflecting radiation
may result in permanent eye injuries. Never look direct in the
laser.
Laser category 2 Power: 10 mW
DIN EN 60825-1:2015-07 Wavelength: 635 nm
Wear a safety helmet!
Wear a safety helmet, when strapping pallets higher than 1.20m.
The duty wearing a helmet, can be avoided, if the user was taught
about the risk of injury by the plastic chain falling.
This instruction has to be recorded in writing.
Warning:
Strap tensioning or strapping, danger of jamming and crushing.
Do not place hands or other body parts between the strap and
the packaged goods during the strapping process. Ensure that
there are no other persons in the hazardous zone..
For an emergency stop in the case of danger (trapped person):
• To release tension (before welding), open the rocker lever.
• After welding, cut the strap with a suitable tool (strap cutter)
To Next Page
Loading...
