7.5 Replacing the length adjusting belt
1. Step (dismantling)
Perform steps 1 to 5 listed in point 7.4 and continue with step 2.
2. Step (dismantling)
Remove these 6 screws of the cover
with a screw driver PZ2 and
remove the two covers.
Thereafter, remove these 3 screws
(4mm allen wrench and 8mm open-
end wrench on opposite side.…
...not the hexagon socket screws
with a 5mm Allen wrench and a
10mm open end wrench on the
opposite side!)
- 60 -
Fig. 82
Fig. 83
To Next Page
Loading...
