ErgoPack 700 - Replacing the Chainlance

7.2 Replacing the ChainLance
1. Step
Disconnect the main
power cable from the
battery pack.
2. Step
Pull out the reversing
sledge by about 1 m,
pull out the
ChainLance of the
strapping system as
shown and roll it up.
3. Step
Push the new ChainLance
in again in reversed
order of the removal.
4. Step
Reconnect the main cable
to the battery pack again,
set the main switch to
position “1“ and put the
strapping system into
operation in accordance
with point 6.2, step 2.
- 56 -
Fig. 75
Fig. 76