ErgoPack 700 - Page 41

21. Step
Remove the pin for
setting the pallet
width from the hole
with the milling
grove…
...and set the requested
pallet width as shown on
the picture by placing the
pin into the next higher
size of your pallet width.
Example 1:
Pallet width 0,80 m-
Put the pin into the 1,0 m
position
Exampel 2:
Pallet width 1,2 m-
Put the pin into the 1,4 m
position
Your ErgoPack is now ready for strapping.
Fig. 48
Fig. 49
- 41 -