EasyManua.ls Logo

Ericsson BDV BS 101 01 - 4 Function Verification

Ericsson BDV BS 101 01
225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5(6)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
1993-11-09 C
1531-RPM 603 339 Uen
INSTALLATION INSTRUCTION
Faktaansvarig - Subject responsible
The temperature sensor may also be directly connect-
ed to the front of CPU-D/1 or AUX/1 at connection
field 6 and CPU-D/2, CPU-E or AUX/2 at connection
field 4.
4 FUNCTION VERIFICATION
4.1 ASB 150 01
Verify on a digital telephone with display that the tem-
perature indication correspond with actual tempera-
ture. Note that there is a set up time after installation of
the temperature sensor on about 1 minute before the
temperature indication starts.
Please note that the indication of temperature trend,
for the first 30 minutes after installation may not be cor-
rect (while reference values are being recorded).
If there is a short cut on the temperature sensor cable,
the temperature indication will show +99° C.
There is no necessity or possibility to adjust the sensi-
tivity of the temperature sensor.
4.2 ASB 150 02
Verify on a digital telephone with display that the tem-
perature indication correspond with actual tempera-
ture. Note that there is a set up time after installation of
the temperature sensor of about 1 minute before the
temperature indication is correct.
Please note that the indication of temperature trend,
for the first 30 minutes after installation may not be cor-
rect (while reference values are being recorded).
If the sensor is open or short circuit there is no indica-
tion (blank) on the telephone display.
There is no necessity or possibility to adjust the sensi-
tivity of the temperature sensor.
1234567890
a
b
a
b
a
b
a
b
a
b
a
b
a
b
a
b
a
b
a
b
External sensor 1
External sensor 2
External sensor 3
26
28
30
32
0 V
Not used
Connection field 4 at the front of CPU-D/2, CPU-E
0 V
0 V
External
AC
Not used
sensor 1
External
sensor 2
External
sensor 3
and AUX/2
18
20
22
24
0 V
Not used
Connection field 6 at the front of CPU-D/1 and AUX/1
0 V
0 V
External
AC
Not used
sensor 1
External
sensor 2
External
sensor 3

Table of Contents