9(11)
Datum -
Date
Rev
Nr -
No.
Uppgjord (även faktaansvarig om annan) -
Prepared
(also subject responsible if other)
Dokansv/Godkänd -
Doc respons/Approved
Kontr -
Checked
File
1998-04-20 B
1531- DBC 211 01 Uen
INSTALLATION INSTRUCTIONS
Option unit function mode settings
LED Number LED ON LED OFF
9 HA level (See below) Normal level
8 Busy signal Extra bell
7 Headset mode Extra handset
6 PC-Audio Tape recorder mode
To change the settings the corresponding buttons can be pressed and the change of status will
be indicated by the associated LED.
To exit the programming mode press # or wait 30 seconds. The settings will now be permanently
stored in the DTS until they are re-programmed.
9.2 Level adaptation for people with impaired hearing (HA-level)
To increase the handset level both for the handset and the headset (for people with impaired
hearing), the LED 9 can be set to on. This will give an extra amplification of 7 dB.
LED 8
LED 9
LED 4
LED 7
LED 5
LED 6
To Next Page
Loading...