Ericsson DT288 - Dial Mode

DURING CALLS
20
BusinessPhone 250 - Portable DT288
BusinessPhone 50 - Portable DT288
DIAL MODE When calling interactive tele services, you must press certain
keys (post dial) to give your response. If your portable uses
tone dialling (DTMF) to make the call, just press the keys
requested by the tele service. If your portable uses pulse-
dialling, you must manually change to tones, after the call is
established:
Note: After you end the call, dialling is always reset to the
default method.
Change to tones When the call is established.
Access ”
DDiiaallMMooddee
”
Select ”
GGoottooDDTTMMFF
” to confirm the change to
tones
Press any key to respond
Some services do not work on standard DTMF tones.
They require long DTMF tones. If so:
Access ”
DDTTMMFF--LLoonngg
”
Send a dial tone
pause If you want to send a dial tone pause when the phone is off
hook, you can use “DialMode - SendPause”.
Select ”
SSeennddPPaauussee
” and press to confirm
A ”-” is displayed and the dial tone pause is sent.
>>GGooTTooDDTTMMFF
>>DDTTMMFF--LLoonngg