51/70
>Control Panel’ and double clicking on ‘Network’. If not,
these components have to be previously added from your
Windows installation disk.
To configure your GPRS connection under a Windows NT PC,
follow steps 1 to 8:
1) Go to ‘My Computer’ and double-click ‘Dial-Up
Networking’.
2) If there are no previously configured connections, the
following wizard will be showed up. Type a name for the
connection and tick ‘I know all about phonebook entries
and would rather edit the properties directly’. Then click
on ‘Finish’; edit properties of this new connection and go
to step 4) to continue with the configuration.
3) Instead of the wizard window, the following window might
come up. In this case, push ‘New…’ button.
To Next Page
Loading...