Standard Test Installation Instructions
1/00021-2/FEA 209 544/21 B 2(4)
1 General
The standard service package consists of a test set, a computer and interface cables. A
hardlockis required for security reasons.
2 Hardware
All test hardware must be approved by Ericsson and is documented in the Equipment List.
2.1 Test set
A test set approved according to the Instruments List must be used.
Test set installation according to the instrument manufacturer instructions.
Test script software and options according to the Instruments List must be present.
2.2 Antenna cable
Connect the antenna cable between the RF-port of the instrument and the antenna connector.
2.3 Computer
IBM compatible computer with Windows 95, Windows 98 or Windows NT.
2.4 Hardlock
Hardlock with article number KRY 105 165 is required. The hardlock should be connected to
the parallel port.
2.5 Service cable
Connect the service cable to one of the serial ports on the PC and to the system connector
according to the figure below.
To Next Page
Loading...
