Mechanical Working Instruction
3/000 21-1/FEA 209 544/21 D 3(20)
# Figure Instruction Note
5 Slide in the top tool under the
front between the LED-diode
and the buzzer holes
6 Place the side-opening tool in
the gap at the top on the phone
and slide it down the phone.
Make sure that the tool always
has contact with the frame
under this operation. Repeat
with the other side
7 Open the phone at the top a
little bit and wobble the frame
sideways to loosen the frame
8 Remove the four display
assembly screws
9 Remove the display assembly
and place it on the ESD-
protected surface
10 Remove the three board
screws.
11 Remove the board and the
metal-gasket carefully from
the frame.
Make sure the SIM-card is
removed
To Next Page
Loading...
