Ericsson R320S - Page 114

N
o
t
f
o
r
C
o
m
m
e
r
c
i
a
l
U
s
e
E
r
i
c
s
s
o
n
M
o
b
i
l
e
C
o
m
m
u
n
i
c
a
t
i
o
n
s
A
B
114 Voice Control
The name (voice label) is played back to you, and the call is connected.
Instead of pressing and holding
YES, as in step 1 above, you can slide and
hold the volume key.
When connected to a portable or vehicle handsfree unit, you can answer or
reject incoming calls by using your voice.
Before you can use voice answering, you need to turn on the voice answering
function and record your voice commands.
To turn on Voice Answering
1. Scroll to
Settings , YES, Handsfree , YES, VoiceAnswering , YES.
2. Select
On .
You now have to train your phone to recognize your voice answering
commands.
3. Press
YES to continue.
4. Follow the instructions in the phone display, i.e. say the word Answer and
press
YES to save your recording. (Use the microphone of the Handsfree
unit). If the recording was not OK, repeat step 3.
5. Say the word Busy and press
YES to save your recordings.
Note! If you prefer, you can use other words instead of ‘Answer’ and ‘Busy’.
To answer an incoming call using your voice
• When the phone rings, say the word Answer.
The word Answer is played back to you and the call will be connected.
To reject an incoming call
• When the phone rings, say the word Busy.
The word Busy is played back to you, and the call is rejected, i.e. the caller
hears a busy tone.
Note! For more information about handsfree units, see “Portable Handsfree”
on page 130 and “Vehicle Handsfree” on page 131.
Voice Answering