Erreka VIVO-M101 - User Manual

9
VIVO-M101(M)
Quick installation and programming guide English
IMPORTANT
NOTE
This quick guide is a summary of the complete installation manual. The manual contains safety warnings
and other explanations which must be taken into account. The installation manual can be downloaded by
going to the "Downloads" section at the Erreka website:
http://www.erreka.com/Automatismos/descargaDocumentos.aspx
E175A
ELECTRICAL CABLING:
Element Nº wires x section Maximum length
A: Main power supply 3x1.5mm
2
30m
B: Flashing light 2x0.5mm
2
20m
C: Photocells (Tx / Rx) 2x0.5mm
2
/ 4x0.5mm
2
30m
D: Pushbutton/wall key 2x0.5mm
2
25m
E: Operator / Limit switches 4x0.75mm
2
/ 4x0.50mm
2
20m
F: Antenna Coaxial cable 50k (RG-58/U) 5m
Elements of the complete installation
MSA-097/01

Summary

Elements of the complete installation

General connections

SW2 Functions during programming

Total opening radio code programming

Procedure for programming radio codes for total opening using DIP switches and transmitter.

Total open;close programming

Procedure for programming total open/close function using DIP switches and pushbuttons.

Pedestrian open;close programming

Procedure for programming pedestrian open/close function using DIP switches and pushbuttons.

Function and mode selection using SW2

DIP Functions and Modes

Detailed explanation of DIP switch functions (DIP1 to DIP12) for mode selection.

Potentiometer adjustment

Instructions for adjusting T.LG, T.E., and P.M. potentiometers for gate operation.

Erreka VIVO-M101 Specifications