Eryone Thinker SE - LCD Layout

14
This section is for LCD layout. Items not mentioned below are not used for the
common print setup-you should not change any of the unmentioned items unless
you are absolutely sure what you are doing.
(The LCD layout based on the latest rmware) Please click the link below to get
the latest rmware: http://dwz1.cc/1obP362
□ Info screen
□ Prepare
□ Move axis
□ Move X
□ Move Y
□ Move Z
□ Auto home
□ Store settings
□ Set Home o󰀨sets
□ Disable steppers
□ Change lament
□ Preheat PLA
□ Preheat PLA End
□ Preheat PLA Bed
□ Preheat ABS
□ Preheat ABS End
□ Preheat ABS Bed
□ Control
□Temperature
□ Nozzle
□ Bed
□ Fan Speed 1 :
□ Fan Speed 2 :
□ Fan Speed 3 :
□ Auto temp
□ MIN
□ Max
□ Fact
□ PID-P
□ PID-I
□ PID-D
□ Preheat PLA conf
□ Preheat ABS conf
6. LCD layout