Eryone Thinker SE - Load the Filament

7
Note: The extruder will not work until the temperature is higher than 170
℃.
(Temperature protection feature)
Preheat your hotend at rst. Click your LCD button→Prepare→Preheat PLA End.
Insert lament into the Teon tube. When the lament goes though extruder block,
with one hand press the handle, make sure the lament can go though the slot of
the gear, then guide lament in by hand till lament starts to string from the hotend.
After pushing the lament into the bottom of hotend,
click LCD button→Prepare→Auto home.
When homing the axis is nished. You can click LCD button→Prepare→Change
lament
Choose “Preheat PLA” the hotend will heating then you need to click the LCD but-
ton to continue.
You can click” Purge more” a few times till the lament comes out of the nozzle.
-Load the lament