16
8. FAQ-Common Assembly issues
If you nd your X carriage is loose. You can use the wrench to tight the nut and
this will remove wobble and slack in the X carriage.
Refer to our forum to get more info if the problem is not listed or the solutions
doesn’t work : https://eryone.com/forum
1) Check if the stepper motor cable is loose
2) You need to check your wires at rst. If it is ok, you can loosen the brass nut
screw a little, this will help it move correctly.
3) Add the lubricant oil to the T8 rod
With pre-designed interface for BLtouch and proximity switch, update Eryone
Thinker SE rmware to enable the auto-leveling function is easily.
8.1 X carriage loose
8.2 Z axis stuck
Compatible with auto-leveling sensors(Not included sensor)
To Next Page
Loading...
