Eryone Thinker SE - Page 4

8. FAQ-Common assembly issues ------------------------------------------------------------
8.1 X carriage loose --------------------------------------------------------------------------
8.2 Z axis stuck----------------------------------------------------------------------------------
9. FAQ-Print problem------------------------------------------------------------------------------
9.1 Filament doesn't stick to the heated bed--------------------------------------------
9.2 Extruder under extrusion----------------------------------------------------------------
10.FAQ-Error messages--------------------------------------------------------------------------
10.1 Mintemp error -----------------------------------------------------------------------------
10.2 Maxtemp error----------------------------------------------------------------------------
10.3 Thermal runaway-------------------------------------------------------------------------
*Add the auto level sensor-----------------------------------------------------------------------
16
16
16
17
17
17
17
17
17
17
17
3