ESAB AUTO K 600 - After Sales Service

b) Cautions for Insulation Voltage-Proof Test & Insulation Resistance
Measurement Test:
Careless execution of Dielectric Strength test and Insulation Resistance Measurement
will cause damage to the power source, since the thyristors, transistors and other
semiconductor parts are widely used in the unit. When these are to be performed in
accordance with the bylaws of your company, the following points should be kept in
mind: -
• Take off the cables from the switch box that are connected to the three input
terminals and short circuit the three input terminals.
• Take off the cable that is connected to two output terminals and short circuit the
two output terminals.
• Short circuit between anode and cathode of thyristors SCRI-6
• Remove the two grounding conductors. (Take off the side panel, and then remove
one conductor nearby the electro-magnetic contactor and also the other conductor
ground to leg of the DC reactor).
I. AFTER SALES SERVICE
In case of any abnormality observed during usage of equipment, which could not be
rectified at site, please contact immediately Area Sales Manager of the nearest unit of
ESAB with the following details:
1) Serial Number of the equipment and type
2) Nature of the complaint with the relevant details, if possible and the details of
Input Supply
3) Date of purchase of the equipment and the date of commissioning.
The qualified and trained service team of ESAB, located at the ESAB Office, render
the after sales service to the customers and also assist in proper selections of Welding
Equipment & consumables for various applications.
11