ESAB EMP 235ic - Advanced Operation: Lift TIG; Lift TIG Operation Procedure

6 CONTROL PANEL
0463 641 001
- 28 -
© ESAB AB 2018
Upslope Sloping the
current up over a period of
time at the beginning of the
weld cycle
Bead profile, concave
Volts Bead profile, convex
Wire feed speed
VRD ON indicator
VoltageReductionDevice
active
Wire diameter
VRD OFF indicator
VoltageReductionDevice
inactive
6.1.12 Lift TIG operation
Touch the Tungsten Electrode to the work piece prior to pressing the TIG Torch Trigger
Switch. With the Trigger depressed lift the Tungsten Electrode from the work piece to initiate
the arc. Once arc initiated refer to 2T/4T Trigger Operation.