SECTION 3 Installation
ESP-400C Plasma Power Source
3-2
WARNING
!
3.3 Placement
Note: Use both lifting eyes when transporting
from overhead.
• A minimum of 2 ft. clearance on front and back
for cooling air flow.
• Plan for top panel and side panels having to be
removed for maintenance, cleaning and
inspection.
• Locate the ESP-400C relatively close to a
properly fused electrical power supply.
• Keep area beneath power source clear for
cooling air flow.
• Environment should be relatively free of dust,
fumes and excessive heat. These factors will
affect cooling efficiency.
CAUTION
Conductive Dust And Dirt Inside
Power Source May Cause Arc Flash-
Over
Equipment damage may occur. Electrical
shorting may occur if dust is allowed to build-up
inside power source. See maintenance section.
3.4 Input Power Connection
Electric Shock Can Kill!
Provide maximum protection against
electrical shock.
Before any connections are made inside
the machine, open the line wall disconnect
switch to turn power off.
Power
Source
To Next Page
Loading...
