6 MAINTENANCE
0463 645 001
- 17 -
© ESAB AB 2020
6.5 Cleaning the swan neck
• Clean the inside of the gas nozzle regularly to remove welding spatter and spray with
ESAB® anti-spatter agent.
• Check the consumables for visible damage and replace if necessary.
6.6 Checking the cooling system
Make sure that the cooling liquid is clean, change it if required. Impurities in the cooling liquid
can obstruct the torch water channels. Always use suitable cooling fluid for torches with
corrosion inhibitors.
To Next Page
Loading...
Need help?
General
