Esco Lexicon - Controller Menu Parameters

Controller
Parameter
Description
Value

Set point – target value
. ... .

Hysteresis
0.2 … 99.9
.
Low set point limit
.
High set point limit

Controller type


Switch on delay after power on
.
Minimum ON time (minimum time the unit is activated)
.
Minimum OFF time (minimum time the unit is deactivated)
Timer
Parameter
Description
Value
.
Defrosting/heating duration
.
Defrosting repeat cycle (only for  controller)
.
Current remaining running time
.
Service interval
.
Service counter
.
Total operating hours

Temperature display during defrosting
.
Response after power-on

Enable start/stop key
.
Function of K-2 relay
0 – no function
1 – signal alarm active
Alarm
Parameter
Description
Value
.
Low alarm limit
-999 … +999
.
High alarm limit
-999 … +999
.
Alarm hysteresis
0.2 … 99.9
.
Alarm suppression time (delay)
.
Sensor over/under range response
Input
Parameter
Description
Value

Sensor
.
Start value for indication range with measurement input voltage or current
.
End value for indication range with measurement input voltage or current
.
Signal for measurement input current
.
Process value offset (for calibration)
-99.9 … 99.9
.
Lead compensation resistance

Unit

Filter time constant
Note: Only the highlighted parameters are used in this UUS product