Esco Provocell - Chapter 4 Operation Guide; Power On Procedure; Temperature, Mixing Time & Speed Setup; Instant Mixing Function

15
Chapter 4 • Operation :
CHAPTER 4
OPERATION GUIDE
This chapter section deals with temperature, mixing time & mixing speed set up. It also explains how to correct for the
difference between the actual and displayed temperature, and how to set up the sounds.
4.1 Power on:
Before turning on the power, check the following:
1. The voltage should comply with specications (Refer to Chapter 2 for the specications).
2. The plug should be plugged into the outlet;
3. The instrument must be earthed
Are you ready? Let’s start!
4.2 Temperature, Mixing time & Orbital Speed Set Up.
a) Approximately 5 seconds after power on, the monitor will
display a temperature of 28.5. The TEMP 100.0 display is the
last set up temperature used. The TIME 80:00 display is the last
mixing time used.The SPEED 1000 display is the last mixing
speed used.
b) TEMP display may be reduced or increased by pressing
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
o r
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
respectively.
TIME display may be reduced or increased by pressing
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
o r
4.3 Instant Mixing
Press
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
to start instant or short period mixing. Press and release the button. The default speed is the maximum
speed (1500rpm).
28.5
OO:OO
1O:OO
TEMP
1OO.O
TIME
8O:OO
SPEED
1OOO
28.5
OO:OO
1O:OO
TEMP
4O.O
TIME
6O:OO
SPEED
1OOO
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
respectively.
These buttons must be pressed for more than 3 seconds to set
the exact value.
If the temperature is set at 40°and the time set at 60:00, keep the
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
depressed until the desired temperature is
reached, release the button, and the temperature will automatically be saved. Next press the
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
and keep depressed
until 60:00 is reached, release the button. The temperature will automatically be save.
28.5
OO:OO
1O:OO
TEMP
6O.O
TIME
8O:OO
SPEED
1OOO
Note: Do not operate the orbital shaker without a block.
c) Press
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
or
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
to program the speed. The number will
increase or reduce at a rate of 50rpm, release the button when
the number reaches the desired speed. When set up is
complete, press
Temp Time
Speed
TimeTemp
Prog
Speed
Start
Stop
Short
to start mixing.