Figure 1.9 – Program and Configure Sensors Window
If you wish to configure your logger’s sensor(s), simply highlight the appropriate sensor(s) and
select the Configure Sensor(s) button located in the top left corner of the ‘Program and Configure’
window. To select multiple sensors, hold the control key (located on your computers keyboard)
down and select the appropriate sensors.
Once you have selected the ‘Configure Sensor(s) button, a new screen will appear that allows
you to add and alter the different features relating to each of your loggers sensors.
Sensor options – Tick to select or deselect
Select to Configure Sensor(s)
To Next Page
Loading...
Need help?
General
