Program window
The final window to be displayed is the ‘Program’ window (see figure 1.17), which is simply an
indication that your updated logger settings are being uploaded into your iLog logger’s memory.
Once your logger has been programmed the ‘Program and Configure’ wizard will allow you to
program additional loggers with the same settings. To do this simply click the ‘Program and
Configure addition devices with the same settings’ tick box located at the bottom left of the
window and select the ‘Next’ button (which will appear after the tick box has been selected) (see
figure 1.18).
Figure 1.17 ‘Program and Configure – Program’ window
To Next Page
Loading...
Need help?
General
