Operation
21 22
To Mark A Location
- Press MRK. The display will read “Mark?” Press MRK again to bring up a menu of markers to
choose from.
- Use the plus and minus buttons to scroll through the markers then press MRK to select the
marker that you wish to use at this location.
- The display will read “Marked!”
Air Patrol locations cannot be marked by the user.
NOTE: When a location is marked the rst time, you must travel at least 1 mile away from that
location to receive an alert when you return to the area.
To Unmark A Location
Touch the MRK button when you are receiving a marked-location alert. The display will read
“Unmark?” Touch the MRK button again to con rm. The display will read “Unmarked!”
Clear Locations
At some point, you may wish to clear some of the data in MAX 4’s database. This may include any of
the following: Defender Database data, Marked locations or false alert Lockouts.
To clear locations in the selected database, select the database then press MUTE to con rm. Format
clears locations in all databases.
Troubleshooting
PROBLEM
Detector beeps brie y at the same location
every day, but no radar source is in sight.
Detector did not alert when a police car was in
view.
Detector’s audible alerts become softer after the
rst few alerts.
The power-on sequence reoccurs while you are
driving.
You wish to restore the factory default settings.
The device will not turn on.
The display is blank.
SOLUTION
A motion sensor or intrusion alarm is located
within range of your route. If you have AutoLearn
enabled, the factory default setting, then MAX 4
will store this signal after about 3 passes and no
longer alert to it.
O cer may not have radar or laser unit turned
on. VASCAR (Visual Average Speed Computer
and Recorder), a stopwatch method of speed
detection, may be in use.
Detector is in AutoMute mode. See “AutoMute”
in the Settings & Preferences section for details.
A loose power connection can cause MAX 4 to
be brie y disconnected and will retrigger the
power-on sequence. Check all connections.
Press and hold the MRK and BRT buttons while
powering on the detector. A “Factory Settings
Restored” message will display, acknowledging
the reset.
Check that vehicle ignition is on.
MAX 4 is in Dark mode. Press the BRT button to
adjust the brightness.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
location to receive an alert when you return to the area.
Red light camera
Red light &
speed camera
Speed camera
Speed trap
Other
To Next Page
Loading...