Operation
PROGRAMMING MENU
Overview
To access the programming menu, press the SEN and MRK buttons. Press the MRK button to
change the selected menu item. Use the - or + button to change the setting on the selected menu
item. Press the MRK button again to return to the selected Menu item.
To exit Programming, simply wait a few seconds without pressing any buttons. A “Completed”
message will display, conrming your selection(s).
Restore Factory Settings
To restore MAX 4 to its original factory settings:
• Press and hold SEN and BRT while turning the power on.
• Factory Settings Restored will display and MAX 4 will reboot.
The following is a list of all settings available in the Programming menu followed by detailed
descriptions of each setting.
Operation
11 12
User Mode Advanced* Access and customize all Settings and Preferences
Novice Access and customize Units and Display Color only, (all other
Settings are set to factory defaults)
NOTE: Switch back to Advanced Mode to view all Preferences.
Pilot Mode Scanning* Display scanning bar and the selected SEN mode
Full Word Displays only the selected SEN mode
Display Color Blue*/Green/Red/Amber Set color to match your vehicle’s dash display
Speed Display On* Displays current speed
Displays battery voltage
Meter Mode Standard* Displays primary alert band with front signal strength bar graph
Spec Displays primary alert band with numeric frequency and only
front signal strength bar graph
Expert Displays up to four alert bands with front and rear signal strength
bar graphs for each
Simple Simple messages replace alert band and signal strength bar
graphs:
Caution (if traveling below Cruise Alert limit)
Slow Down (if traveling above Cruise Alert limit)
Cruise Alert 20 mph*
Offers only double beep alert tones below the specified speed
Off/20-160 mph
Over Speed 70 mph*
Alerts when the specified speed is exceeded
Off/20-160 mph
To Next Page
Loading...