Escort MAX Series - Marking Locations; Clearing Locations; Wi-Fi Connectivity

Operation
23 24
To Mark A Location
- Press MRK. The display will read “Mark?” Press MRK again to bring up a menu of markers to
choose from.
- Use the plus and minus buttons to scroll through the markers then press MRK to select the marker
that you wish to use at this location.
- The display will read “Marked!”
Air Patrol locations cannot be marked by the user.
Note: When a location is marked the first time, you must travel at least 1 mile away from that location to
receive an alert when you return to the area.
To Unmark A Location
Touch the MRK button when you are receiving a marked-location alert. The display will read “Unmark?”
Touch the MRK button again to confirm. The display will read “Unmarked!”
Clear Locations
At some point, you may wish to clear some of the data in MAXcam 360c MKII’s database. This may
include any of the following: Defender Database data, Marked locations or false alert Lockouts.
To clear locations in the selected database, select the database then press BRT twice to confirm. Format
clears locations in all databases.
Wi-Fi
Turns on and off Wi-Fi connection to a hotspot.
NOTE: Compatible with 2.4 and 5 GHz hotspots.
Troubleshooting
PROBLEM
Detector beeps briefly at the same location every
day, but no radar source is in sight.
Detector did not alert when a police car was in
view.
Detector’s audible alerts become softer after the
first few alerts.
The power-on sequence reoccurs while you are
driving.
You wish to restore the factory default settings.
The device will not turn on.
The display is blank.
SOLUTION
A motion sensor or intrusion alarm is located within
range of your route. If you have AutoLearn enabled,
the factory default setting, then MAX 360c MKII will
store this signal after about 3 passes and no longer
alert to it.
Officer may not have radar or laser unit turned
on. VASCAR (Visual Average Speed Computer
and Recorder), a stopwatch method of speed
detection, may be in use.
Detector is in AutoMute mode. See “AutoMute” in
the Settings & Preferences section for details.
A loose power connection can cause MAX 360c
MKII to be briefly disconnected and will retrigger
the power-on sequence. Check all connections.
Press and hold the MRK and BRT buttons while
powering on the detector. A “Factory Settings
Restored” message will display, acknowledging the
reset.
Check that vehicle ignition is on.
MAX 360c MKII is in Dark mode. Press the BRT
button to adjust the brightness.