InstallationInstallation
7 8
Your new detector comes with our latest EZ Mag Mount™. Simply slide the detector onto the
mounting bracket fully and that’s it. To remove the detector from the mount, simply pull the
detector off of the mount.
Mounting Tips:
• Center of windshield between driver and passenger.
• Ensure clear view of road ahead and sky above.
• Avoid windshield wipers and heavily tinted areas.
To Mount the Detector in Your Vehicle:
1 Remove backing from EZ Mag Mount.
2 Firmly press the EZ Mag Mount onto the windshield and flip the locking clamp to secure.
3 Tilt the display end of the detector slightly upward and engage with the mounting bracket.
The EZ Mag Mount magnet holds the detector firmly in place.
4 To adjust view, loosen thumb wheel and adjust angle of mounting bracket. Tighten thumb
wheel to secure.
5 To remove the detector, simply lift the display end of the detector upward. The detector will
from the mount.
6 To remove the mount from windshield, release the locking clamp and pull the tab on top of
the EZ Mag Mount.
EZ Mag Mount Care Instructions:
To clean your EZ Mag Mount, simply rinse under warm water, gently wipe off any debris and
allow to air dry.
To Next Page
Loading...
