Escort MAX Series - Programming Menu Overview; Restore Factory Settings

Operation
PROGRAMMING MENU
Overview
• To access the programming menu, press the SEN and BRT buttons.
• Press the SEN button to change the selected menu item.
• Use the - or + button to change the setting on the selected menu item.
• Press the SEN button again to return to the selected Menu item.
To exit Programming, press the Power button or simply wait a few seconds without pressing any
buttons. A “Completed” message will display, confirming your selection(s).
Restore Factory Settings
To restore MAX 360c MKII to its original factory settings, press and hold the MRK and BRT buttons while
powering on. “Factory Settings Restored” will display.
Operation
13 14
User Mode Advanced* Access and customize all Settings and Preferences
Novice Access and customize Units and Display Color only, (all other
Settings are set to factory defaults)
NOTE: Switch back to Advanced Mode to view all Preferences.
Pilot Mode Scanning* Display scanning bar and the selected SEN mode
Full Word Displays only the selected SEN mode
Arrow Mode Single* Displays a single threat-direction arrow for the primary alert
Multiple Displays threat-direction arrows for multiple alerts
Band
Displays color-coded threat-direction arrows for multiple alert bands
X = green, K = blue, Ka/Laser = red
Display Color Blue*/Green/Red/Amber Set color to match your vehicle’s dash display
Speed Display On* Displays current speed
Displays battery voltage
Over Spd Limit Off/Spd Limit*/5 Over/
7 Over/10 Over/15 Over/
20 Over/25 Over
Alerts when the specied speed over the speed limit has
been exceeded
NOTE: only applicable when connected to a mobile Wi-Fi hotspot
Meter Mode Standard Displays primary alert band with front signal strength bar graph
Stand FR1* Displays primary alert band and signal counter with front and
rear signal strength bar graphs
Standard FR2 Displays primary alert band and signal counter with front and
rear signal strength bar graphs
Spec Displays primary alert band with numeric frequency and only
front signal strength bar graph
Spec FR1 Displays primary alert band, numeric frequency and signal
counter with front and rear signal strength bar graphs
Spec FR2 Displays primary alert band, numeric frequency and signal
counter with front and rear signal strength bar graphs for primary
and secondary alerts
Expert FR Displays up to four alert bands with front and rear signal strength
bar graphs for each
Simple Simple messages replace alert band and signal strength bar
graphs:
Caution (if traveling below Cruise Alert limit)
Slow Down (if traveling above Cruise Alert limit)
Cruise Alert 20 mph*
Offers only double beep alert tones below the specied speed
Off/20-160 mph
Over Speed 70 mph*
Alerts when the specied speed is exceeded
Off/20-160 mph
The following is a list of all settings available in the Preferences menu followed by detailed descriptions of
each setting.