MAYA44 ESI
7.2. Cakewalk SONAR
There are few steps must be done for the SONAR which may supports either WDM and ASIO. After
launching SONAR, go to Options -> Audio….
1. WDM/KS mode – Change the settings as below on Input / Output Drivers settings.
The input and output drivers have to be matched to each other. Restart the SONAR after the settings have
changed.
2. ASIO mode
*ASIO mode is supported from SONAR 2.X release on. With MAYA4, ASIO mode is recommended over
WDM mode.
First, change the Driver Mode to ASIO on the Advanced tab of the Audio Option as below. Then, restart the
SONAR.
26
To Next Page
Loading...
