Esko Kongsberg XP - Unpack the Equipment; Installation; Start-Up and Shut-Down Procedures; What Can the System be Used for

6
5. Unpack the equipment
Only Esko-Graphics Service Engineers are allowed to unpack the equipment.
6. Installation
Only Esko-Graphics Service Engineers are allowed to install the equipment.
7. Start-up and Shut-down procedures
7.1 Start up
 Turn on the PC.
 From the desktop, start XP-Guide.
 Follow the start-up procedure described in the User Manual.
7.2 Shut down
 Follow the shut-down procedure described in the User Manual.
8. Table operation
For detailed information on how to operate the system, be familiar with the User Manual and
complete the following sequences:
 Get started.
 Basic operation.
 Table setup.
 Tool heads and tools.
9. What can the system be used for?
The system is designed for use within applications, materials, tools and workflow as described in the
How to.. chapter in the User Manual. Any other use is considered non-intended use.
Examples of non-intended use:
 Operation by operators not meeting the requirements as described above.
 Unauthorized modifications (bridging safety devices, removing covers etc.)
 Utilizing accessories other than those specified by Esko-Graphics.
Non-intended use may cause:
 Health hazards and injuries.
 Damage to the system.
 Incorrect functionality.