Esko Kongsberg XP - 10. Who Are Allowed to Use the System; 11. Software Updates; 12. Maintenance

7
 Damage to work materials.
Esko-Graphics is not liable for use of the system when these guidelines are not followed.
10. Who are allowed to use the system?
Only personnel trained by Esko-Graphics authorized personnel are allowed to operate the system.
Training will be given to customer appointed operator(s) by the Esko-Graphics Service Engineer as
part of the installation. The training covers:
 Safety regulations
 Start-up and shut-down procedures
 Online help
 Set-up procedures
 Adjustment procedures
 Workflow
 Maintenance
For additional training courses contact Esko-Graphics Service Organization.
Un-trained personnel shall under no circumstances be allowed to operate the system!
11. Software updates
Follow the installation procedure on the CD cover.
The procedure is also described in the User Manual.
12. Maintenance
The maintenance done by the customer is limited to preventive maintenance. This is described in
the User Manual.
Any other maintenance, repair, replacement of parts etc. must be done by Esko-Graphics
authorized personnel only.